Subaru Crosstrek Service Manual: Hvac system (heater, ventilator and a/c)
- Air conditioning system
- Air mix door actuator
- Air vent grille
- Ambient sensor
- Blower motor
- Blower motor unit assembly
- Blower resistor (manual a/c model)
- Compressor
- Compressor oil
- Condenser
- Control panel
- Evaporator
- Evaporator sensor
- Expansion valve
- Fresh/recirc door actuator
- General description
- Heater and cooling unit
- Heater core
- Heater duct
- Heater vent duct
- Hose and pipe
- In-vehicle sensor (auto a/c model)
- Mode door actuator
- Power transistor (auto a/c model)
- Refrigerant pressure with manifold gauge set
- Relay and fuse
- Sunload sensor (auto a/c model)
- A/c filter Replacement
- Diagnostics with phenomenon Inspection
- Pressure switch (triple pressure switch) Inspection
- Refrigerant charging procedure Procedure
- Refrigerant leak check Inspection
- Refrigerant recovery procedure Procedure
Subaru select monitor Operation
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Subaru Select MonitorOPERATIONFor detailed operation procedures, refer to “Application help”.NOTE:When initialization communication using Select M ...
Other materials:
If you have accidentally triggered the alarm system
To stop the alarm
Do any of the following operations
Press any button on the access key/
remote transmitter.
Turn the ignition switch to the "ON"
position (models without "keyless access
with push-button start system").
Turn the push-button ignition to the
"ACC" position (models wit ...
Operation
HI - Rapid heating
LO - Normal heating
Off
Left-hand side
Right-hand side
To turn on the seat heater, push the "LO"
or "HI" position on the switch, as desired,
depending on the temperature.
Selecting the "HI" position will cause the
seat to heat up quicker.
To turn off ...
Bulb chart
NOTE
Lights A and B are the LED (Light Emitting Diode) type. Consult your
SUBARU dealer for replacement.
Wattage
Bulb No.
1) High beam headlight
12V-60W
HB3
2) Low beam headlight
Models with HID light
Models with halogen light
...
