Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Blower resistor (manual a/c model)

Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Motor Unit AssemblyREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” ...

Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)INSPECTION1. Check the resistance between resistor terminals.Preparation tool:Circuit testerTerminal No.StandardConnecti ...

Other materials:

Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Converter CaseASSEMBLY1. Install the oil drain plug.Tightening torque:70 N·m (7.1 kgf-m, 51.6 ft-lb)2. Install the overflow drain plug.NOTE:Overflow plug of differential gear oil is temporarily attached.3. Install all plugs.NOTE:Use new O-rings.T ...

Dtc p0131 a/f / o2 sensor circuit low voltage bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0131 A/F / O2 SENSOR CIRCUIT LOW VOLTAGE BANK 1 SENSOR 1DTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...

Dtc p2747 intermediate shaft speed sensor "b" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2747 INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• Shock o ...

© 2016-2025 Copyright www.sucross.com