Subaru Crosstrek Service Manual: Telematics system (diagnostics)
- Control module i/o signal
- Diagnostic code(s) display
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b2a01 tel1 antenna circuit
- Dtc u0452 invalid data received from restraints control module
- Dtc b2a02 tel2 antenna circuit
- Dtc u0100 lost communication with ecm/pcm a
- Dtc b2a00 vin reading
- Dtc b2a03 gps antenna circuit
- Dtc b2a04 mic circuit
- Dtc b2a05 left speaker/audio circuit
- Dtc b2a06 right speaker/audio circuit
- Dtc b2a08 sos button circuit
- Dtc b2a09 i-call button circuit
- Dtc b2a0a red led circuit
- Dtc b2a0b green led circuit
- Dtc b2a0c dcm internal fault
- Dtc b2a0d airbag signal
- Dtc b2a0e mute line circuit
- Dtc b2a0f backup battery degradation
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0140 lost communication with body control module
- Dtc u0151 lost communication with restraints control module
- Dtc b2a07 backup battery charge system performance
- Dtc b2a10 battery voltage high
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc u0401 invalid data received from ecm/pcm a
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0073 control module communication bus off
- Diagnostics with phenomenon
- General description
- Read current data
- Subaru select monitor
- System operation check mode
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Electrical component location Location
- Inspection mode Procedure
Installation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeINSTALLATIONCAUTION:For installation of the stereo camera cover assembly, refer to “INSTALLATION”, “Stereo Camera” in the & ...
Other materials:
Dtc c0037 rl hold valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0037 RL HOLD VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...
Installation
SECURITY AND LOCKS > Starter Relay (Push Button Start)INSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the reverse o ...
