Subaru Crosstrek Service Manual: Instrumentation/driver info (diagnostics)
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0100 lost communication with ecm/pcm a
- Dtc b2222 system microcomputer fail
- Dtc u0101 lost communication with tcm
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0131 lost communication with power steering control module
- Dtc u0140 lost communication with body control module
- Dtc u0151 lost communication with restraints control module
- Dtc b2223 gerda malfunction
- Dtc u0164 lost communication with hvac control module
- Dtc u0327 software incompatibility with vehicle security control module
- Dtc b1500 fuel sender open/short-circuit detection
- Dtc b1507 external air temperature open/short-circuit detection
- Dtc b1501 power supply system error detection
- Dtc u0073 control module communication bus off
- Dtc u1201 can-hs counter abnormal
- Dtc u1650 invalid data received from meter (uart)
- Dtc u1651 lost communication with meter (uart)
- Dtc b2220 break the wire of ign
- General description
- Read current data
- Subaru select monitor
- System operation check mode
- User customizing
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Control module i/o signal Electrical specification
- Electrical component location Location
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
Subaru select monitor Operation
IMMOBILIZER (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE THE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. READ DIAGNOSTIC TROUBL ...
Other materials:
Dtc u0422 invalid data received from body control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULEReceived error data from BIU.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...
Remote keyless entry system
CAUTION
Do not expose the remote transmitter
to severe shocks, such as
those experienced as a result of
dropping or throwing.
Do not take the remote transmitter
apart except when replacing
the battery
Do not get the remote transmitter
wet. If it gets wet, wipe it dry with
a clo ...
