INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > User Customizing
OPERATION
1. COMBINATION METER
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Combination Meter» and then select «Enter».
5. On «Select Function» display, select «Customize».
6. On «Customize» display, select an item to be customized.
NOTE:
• For detailed operation procedures, refer to “Application help”.
• If not equipped (depending on destination area or vehicle equipment condition), some items are not displayed.
Installation
CONTROL SYSTEMS > MT Gear Shift LeverINSTALLATION1. Insert the gear shift lever from the room side.NOTE:Insert the rod and the stay, and then temporarily set them onto the transmission mount.2. Lift up the vehicle.3. Install the joint to the transmission and secure with a spring pin.(A)Joint(B)Sp ...
Shifting speeds
Recommended shifting speeds
The best compromise between fuel economy
and vehicle performance during
normal driving is ensured by shifting up
at the speeds listed in the following table.
Maximum allowable speeds
The following table shows the maximum
speeds that are possible with each differe ...
Inspection
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD) SystemINSPECTION• Standard typeRefer to the following inspection steps. Multi-function Display (MFD) System > INSPECTION">• High grade typeRefer to “Basic Diagnostic Procedure” of “INSTRUMENTATION ...