Subaru Crosstrek Owners Manual: Loading your vehicle
WARNING
- Never allow passengers to ride
on a folded rear seatback or in
the cargo area. Doing so may
result in serious injury.
- Never stack luggage or other
cargo higher than the top of the
seatback because it could tumble
forward and injure passengers in
the event of a sudden stop or
accident. Keep luggage or cargo
low, as close to the floor as
possible.

WARNING
- When you carry something inside
the vehicle, secure it whenever
you can to prevent it from being
thrown around inside the vehicle
during sudden stops, sharp turns
or in an accident.
- Do not pile heavy loads on the
roof. These loads raise the vehicle's
center of gravity and make it
more prone to tip over.
- Secure lengthy items properly to
prevent them from shooting forward
and causing serious injury
during a sudden stop.
- Never exceed the maximum load
limit. If you do, some parts on
your vehicle can break, or it can
change the way your vehicle
handles. This could result in loss
of control and cause personal
injury. Also, overloading can
shorten the life of your vehicle.
- Do not place anything on the
extended cargo area cover. Such
items could tumble forward in the
event of a sudden stop or a
collision. This could cause serious
injury.
CAUTION
Do not carry spray cans, containers
with flammable or corrosive liquids
or any other dangerous items inside
the vehicle.
NOTE
For better fuel economy, do not carry
unneeded cargo.
If you must rock the vehicle to free it from
snow, sand, or mud, depress the accelerator
pedal slightly and move the shift
lever/select lever back and forth between
"1"/"D" and "R" repeatedly. Do ...
Vehicle placard
The load capacity of your vehicle is
determined by weight, not by available
cargo space. The maximum load you can
carry in your vehicle is shown on the
vehicle placard att ...
Other materials:
Removal
POWER ASSISTED SYSTEM (POWER STEERING) > Universal JointREMOVAL1. Adjust the tilt position of the column assembly - steering to the lowest position and lock the tilt lever.2. Remove the universal joint assembly - steering.(1) Place alignment marks on the universal joint assembly - steering.NOTE:P ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel FilterREMOVALWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:• Be careful not to spill fuel.• If the fuel gauge indicates that two thirds or more of the fuel is remaining, be sure to drain fuel before starting w ...
Reclining the seatback
Pull the reclining lever up and adjust the
seatback to the desired position. Then
release the lever and make sure the
seatback is securely locked into place.
The seatback placed in a reclined position
can spring back upward with force when
the lever is pulled. While operating the
lever ...
© 2016-2025 Copyright www.sucross.com
