Subaru Crosstrek Service Manual: Inspection mode Procedure
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Inspection Mode
PROCEDURE
Reproduce the malfunction occurrence condition as much as possible. Drive the vehicle at 40 km/h (25 MPH) or faster for at least ten minutes.
General diagnostic table Inspection
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General Diagnostic TableINSPECTIONSymptomsFaulty partsTire pressure warning light illuminates.Tire pressure is reduced.• Improper tire pressure ...
List of diagnostic trouble code (dtc) List
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTDTCItemContents of diagnosisRemarksC2021TIRE 1 AIR PRESSURE LOW (NORMAL MODE)Tire pressure of tire 1 is redu ...
Other materials:
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Control PanelINSPECTION1. CHECK ILLUMINATION1. Check the illumination operation when battery voltage is applied between the terminals of control panel.• Manual A/C modelTerminal No.Inspection conditionsSpecificationConnection diagram14 (+) — 12 ( ...
Abbreviation in wiring diagrams
WIRING SYSTEM > Basic Diagnostic ProcedureABBREVIATION IN WIRING DIAGRAMSAbbr.Full nameABSAnti-lock Brake SystemACCAccessoryA/CAir ConditionerASSYAssemblyATAutomatic TransmissionA/FAir/Fuel (air fuel ratio sensor)ATFAutomatic Transmission FluidAUXAuxiliary Audio Input TerminalAWDAll Wheel DriveB, ...
Pressure switch (triple pressure switch) Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Pressure Switch (Triple Pressure Switch)INSPECTION1. Connect the manifold gauge to the service valve on the high-pressure side.2. Disconnect the connector.3. Start the air conditioner, and check the operating pressure of switch by turning the compressor ...