Subaru Crosstrek Owners Manual: System malfunction indicator
System malfunction indicator
- At first, this message will appear
- Then this message will appear
This indicator appears when a malfunction occurs in the system. Contact a SUBARU dealer and have the system inspected.
System temporary stop indicator due to reduced radar sensitivity
System temporary stop indicator due to reduced radar sensitivity
This indicator appears when the detectability
of the radar sensors is reduced.
Once the condition is corrected, the
system wi ...
BSD/RCTA OFF switch
BSD/RCTA OFF switch
BSD/RCTA OFF indicator
If the BSD/RCTA OFF switch is pressed,
the BSD/RCTA OFF indicator appears on
the multi information display of the combination
meter, and the BSD ...
Other materials:
Installation
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorINSTALLATIONCAUTION:Be careful not to damage the sensor.1. Install each part in the reverse order of removal.2. Route the rear ABS wheel speed sensor cable to the upper arm assembly.NOTE:Check the identification (mark) on the harness to ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSTALLATION1. Install the check ball spring and check ball to the reverse fork rod arm, and press in the ST.ST 399411700ACCENT BALL INSTALLER2. Install the reverse fork rod through the hole on the rear of the transmission case. P ...
Assembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterASSEMBLY1. Apply grease to the shaft sliding surfaces of the internal gear assembly.Grease:Multemp #6129 or equivalent2. Assemble the shaft to the internal gear assembly.3. Assemble the overrunning clutch as follows:(1) Apply grease to the spline portion o ...