Subaru Crosstrek Owners Manual: Starting and operating
- Fuel
- State emission testing (U.S. only)
- Preparing to drive
- Starting and stopping the engine (models without push-button start system)
- Starting and stopping engine (models with push-button start system)
- Remote engine start system (dealer option)
- Models with "keyless access with push-button start system"
- Models without "keyless access with push-button start system"
- Entering the vehicle while it is running via remote start
- Service mode (models without "keyless access with push-button start system")
- Remote transmitter program (models without "keyless access with push-button start system")
- System maintenance
- Manual transmission
- Continuously variable transmission
- Continuously variable transmission features
- Select lever
- Selection of manual mode
- Shift lock function
- Driving tips
- Power steering
- Braking
- ABS (Anti-lock Brake System)
- Electronic Brake Force Distribution (EBD) system
- Vehicle Dynamics Control system
- Tire pressure monitoring system (TPMS) (U.S.-spec. models)
- Parking your vehicle
- Hill start assist system
- Cruise control (if equipped)
- BSD/RCTA (if equipped)
Help line
The help line (distance marker and vehicle
width line) is a guide to help you realize
the actual distance from the screen image.
1) Vehicle width line (oblique vertical line)
2) Approx. 10 feet ...
Fuel
CAUTION
Use of a fuel which is low in quality
or use of an inappropriate fuel
additive may cause damage to the
engine and/or fuel system. ...
Other materials:
Engine oil pressure Inspection
MECHANICAL(H4DO) > Engine Oil PressureINSPECTION1. Disconnect the ground cable from battery. NOTE">2. Remove the oil pressure switch. Oil Pressure Switch > REMOVAL">3. Install the oil pressure gauge to the chain cover.4. Connect the battery ground terminal. NOTE">5. ...
Dtc b1655 front buckle switch rh failure
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1655 FRONT BUCKLE SWITCH RH FAILUREDiagnosis start condition:Ignition voltage is 8 V to 16 V.DTC detecting condition:• Passenger’s buckle switch circuit is open, shorted or shorted to ...
Installation
DRIVE SHAFT SYSTEM > Front AxleINSTALLATION1. Install the front drive shaft assembly.CAUTION:• Do not hammer the drive shaft assembly when installing.• Use new axle nuts.(1) Insert the drive shaft assembly into the hub spline, and pull it into the specified position.(2) Tighten the ax ...
