Subaru Crosstrek Service Manual: Note
LIGHTING SYSTEM > Auto Headlight Beam Leveler System
NOTE
For operation procedures of each component of the auto headlight beam leveler system, refer to the respective section.
• Auto headlight beam leveler CM: Auto Headlight Beam Leveler Control Module">
• Vehicle height sensor: Rear Height Sensor">
Procedure
LIGHTING SYSTEM > Auto Headlight Beam Leveler SystemPROCEDUREWhen parts related to the auto headlight beam leveler system are removed or replaced, perform the following procedures to initialize or ...
Wiring diagram
LIGHTING SYSTEM > Auto Headlight Beam Leveler SystemWIRING DIAGRAMRefer to “Headlight Beam Leveler System” in the wiring diagram. Headlight Beam Leveler System > WIRING DIAGRAM" ...
Other materials:
Hill start assist warning light/Hill start assist OFF indicator light
Hill
start assist warning light
While the engine is running, if there are
any malfunctions in the Hill start assist
system, the warning light will illuminate.
WARNING
When the Hill start assist warning
light illuminates, have the vehicle
inspected at an authorized SUBARU
dealer.
Hill st ...
Selecting a channel from the list
1. The categories list is displayed via
either of the following procedures.
When you touch the
tab in the
SiriusXM main screen (if the list that
was displayed the last time is Categories).
When you select the tab in
each
list screen.
2. Each channel list is displayed whe ...
General diagnostic table Inspection
DRIVE SHAFT SYSTEM > General Diagnostic TableINSPECTIONNOTE:Vibration while cruising may be caused by an unbalanced tire, improper tire inflation pressure, improper wheel alignment, etc.SymptomsPossible causeCorrective actionNoise or vibration from propeller shaft• Center bearing• Run ...
