Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Keyless Access System
INSPECTION
1. KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM
Refer to “Basic Diagnostic Procedure” of “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. Basic Diagnostic Procedure">
Wiring diagram
SECURITY AND LOCKS > Keyless Access SystemWIRING DIAGRAMFor wiring diagrams related to the keyless access system, refer to the following items.• Keyless access system: Keyless Access System ...
Keyless buzzer
...
Other materials:
Assembly
WIPER AND WASHER SYSTEMS > Wiper BladeASSEMBLY1. FRONT1. Insert the rubber assembly - windshield wiper onto the blade - windshield wiper so that the stopper is in the position shown in the figure.2. Make sure the rubber assembly - windshield wiper is securely fastened to the pull stopper (a).2. R ...
Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remove the snap ring from outer race (PTJ).4. Remove the outer race (PTJ) from shaft assembly.5. Wipe off ...
Dtc p0037 a/f / o2 heater control circuit low bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0037 A/F / O2 HEATER CONTROL CIRCUIT LOW BANK 1 SENSOR 2DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear M ...
