Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Front Hood Lock Assembly
INSPECTION
Check if the lock assembly operates normally.
If lever deformation, abnormal wear, or unsmooth lock operation is observed, replace the lock assembly - front hood.
Removal
SECURITY AND LOCKS > Front Hood Lock AssemblyREMOVAL1. Open the front hood.2. Remove the clip, and remove the bracket - grille.NOTE:To prevent damage to the bracket - grille, make sure to remove al ...
Installation
SECURITY AND LOCKS > Front Hood Lock AssemblyINSTALLATION1. Before installation, check the following items.• Is the cable deformed?• Grease is applied sufficiently to cable joints.If gr ...
Other materials:
Preparation tool
POWER ASSISTED SYSTEM (POWER STEERING) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS34099PA100SPANNERUsed when measuring the rotational resistance of gearbox assembly. — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting ...
Starting engine
1. Apply the parking brake.
2. Shift the select lever into the "P"
position.
3. Depress the brake pedal.
4. Hold the access key with the buttons
facing you, and touch the push-button
ignition switch with it.
When the communication between the
access key and the vehicle is completed ...
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...
