Subaru Crosstrek Service Manual: Door switch

Installation

LIGHTING SYSTEM > Day Time Running ResistorINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Resistor assembly - daytime running light: 7.5 N·m (0.76 kgf-m, 5.5 ...

Inspection

LIGHTING SYSTEM > Door SwitchINSPECTION1. Check the resistance between switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnection diagram1 — 3When door is ...

Other materials:

Inspection
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSPECTION1. Moving the rear tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the rear hub unit bearing.2. Inspe ...

Inspection locations after a collision Inspection
AIRBAG SYSTEM > Inspection Locations after a CollisionINSPECTIONIf the vehicle is involved in a collision, even if it is a slight collision, be sure to check the following systems.1. DRIVER’S AIRBAG MODULE ASSEMBLY1. Frontal collision (driver’s airbag module assembly activated)(1) Rep ...

Checking the fluid level
WARNING Never let clutch fluid contact your eyes because clutch fluid can be harmful to your eyes. If clutch fluid gets in your eyes, immediately flush them thoroughly with clean water. For safety, when performing this work, wearing eye protection is advisable. CAUTION Clutch fluid ab ...