Subaru Crosstrek Owners Manual: Checking the brake pedal reserve distance
1) More than 2.56 in (65 mm)
Depress the pedal with a force of approximately 66 lbf (294 N, 30 kgf) and measure the distance between the upper surface of the pedal pad and the floor.
When the measurement is smaller than the specification, or when the pedal does not operate smoothly, contact with your SUBARU dealer.
Checking the brake pedal free play
1) 0.02 - 0.11 in (0.5 - 2.7 mm)
Turn the ignition switch to the "LOCK"/
"OFF" position and firmly depress the
brake pedal several times. Lightly pull
the brake pedal up with one finger to
ch ...
Clutch pedal (MT models)
Check the clutch pedal free play according
to the maintenance schedule in the
"Warranty and Maintenance Booklet". ...
Other materials:
Dtc p2009 tgv control circuit low bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2009 TGV CONTROL CIRCUIT LOW BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION"& ...
Removal
EXTERIOR BODY PANELS > Rear GateREMOVALCAUTION:The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.1. REAR GATE PANEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REM ...
Rear tie-down holes
Rear tie-down hole
The rear tie-down holes are located near
each of the jack-up reinforcements.
There is a plug in each rear tie-down hole.
To use the rear tie-down holes, remove
the plugs. After using the rear tie-down
holes, return the plugs to their original
places.
WARNING
...