Subaru Crosstrek Service Manual: Blind spot detection/rear cross traffic alert (diagnostics)
- Control module i/o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0101 lost communication with tcm
- Dtc u0073 control module communication bus off
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0140 lost communication with body control module
- Dtc b2300 rear radar circuit low
- Dtc b2301 rear radar circuit high
- Dtc b2304 rear radar on-off switch stuck
- Dtc b2311 rear radar detect tcm
- Dtc b2313 rear radar detect vdc
- Dtc b2327 rear radar internal failure (internal electric circuit)
- Dtc b2329 rear radar axis alignment incomplete
- Dtc b2350 rear radar communication error between master and slave
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc u0402 invalid data received from tcm
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0422 invalid data received from body control module
- Dtc u0423 invalid data received from instrument panel cluster control module
- General description
- Read current data
- Subaru select monitor
- System operation check mode
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Diagnostic procedure with cancel code Dtc b2328 rear radar internal failure (radar misalignment)
- Diagnostics with phenomenon Inspection
- Electrical component location Location
- Inspection mode Operation
- List of cancel code List
- List of diagnostic trouble code (dtc) List
- Read cancel code Operation
- Read diagnostic trouble code (dtc) Operation
Read diagnostic trouble code (dtc) Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target veh ...
Other materials:
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSPECTION1. Check the shifter fork and fork rod for damage. Replace if it is damaged.2. Gearshift mechanismRepair or replace the gearshift mechanism if excessively worn, bent or defective in any way.3. Inspect the clearance between ...
Caution
EyeSight > General DescriptionCAUTION• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before ...
How to change the source
The USB Audio playback screen can be
reached by the following methods:
Connect a USB memory. Refer to
"Connecting and disconnecting a USB
memory/portable device"
Select the "USB/iPod" key on the
source select screen. Refer to "Selecting
an audio source"
Select play mode
The play m ...
