Subaru Crosstrek Service Manual: Instrumentation/driver info (diagnostics)
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0100 lost communication with ecm/pcm a
- Dtc b2222 system microcomputer fail
- Dtc u0101 lost communication with tcm
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0131 lost communication with power steering control module
- Dtc u0140 lost communication with body control module
- Dtc u0151 lost communication with restraints control module
- Dtc b2223 gerda malfunction
- Dtc u0164 lost communication with hvac control module
- Dtc u0327 software incompatibility with vehicle security control module
- Dtc b1500 fuel sender open/short-circuit detection
- Dtc b1507 external air temperature open/short-circuit detection
- Dtc b1501 power supply system error detection
- Dtc u0073 control module communication bus off
- Dtc u1201 can-hs counter abnormal
- Dtc u1650 invalid data received from meter (uart)
- Dtc u1651 lost communication with meter (uart)
- Dtc b2220 break the wire of ign
- General description
- Read current data
- Subaru select monitor
- System operation check mode
- User customizing
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Control module i/o signal Electrical specification
- Electrical component location Location
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
Subaru select monitor Operation
IMMOBILIZER (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE THE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. READ DIAGNOSTIC TROUBL ...
Other materials:
Dtc p2758 torque converter clutch pressure control solenoid control circuit stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2758 TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:The e ...
32
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code32This DTC is detected out of vehicle speed range.Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.If cancel code is still detected after setting cruise a ...
Removal
BRAKE > Front Disc Brake AssemblyREMOVALCAUTION:Do not allow brake fluid to come in contact with the painted surface of the vehicle body. If it does, wash off with water and wipe away completely.1. Lift up the vehicle, and then remove the front wheels.2. Remove the caliper body assembly.(1) Remov ...
