Subaru Crosstrek Service Manual: Fuel injection (fuel systems)(h4do)
- Camshaft position sensor
- Crankshaft position sensor
- Crankshaft position sensor plate
- Electronic throttle control relay
- Engine control module (ecm)
- Engine coolant temperature sensor
- Engine oil temperature sensor
- Engine wiring harness
- Front oxygen (a/f) sensor
- Fuel delivery and evaporation lines
- Fuel filler pipe
- Fuel filter
- Fuel injector
- Fuel level sensor
- Fuel pump
- Fuel pump relay
- Fuel sub level sensor
- Fuel tank
- Fuel tank protector
- General description
- Intake manifold
- Knock sensor
- Main relay
- Manifold absolute pressure sensor
- Mass air flow and intake air temperature sensor
- Oil control solenoid
- Rear oxygen sensor
- Throttle body
- Tumble generator valve actuator
- Tumble generator valve assembly
- Fuel Procedure
- Fuel system trouble in general Inspection
- Throttle position sensor Specification
General diagnostic table Inspection
FRONT SUSPENSION > General Diagnostic TableINSPECTION1. IMPROPER VEHICLE POSTURE OR IMPROPER WHEEL ARCH HEIGHTPossible causeCorrective action(1) Permanent distortion or damage of the coil springRep ...
Other materials:
Dtc p0336 crankshaft position sensor "a" circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0336 CRANKSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Failure ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Intake ManifoldREMOVAL1. Release the fuel pressure. Fuel > PROCEDURE">2. Disconnect the ground cable from battery.3. Open the fuel filler lid and remove the fuel filler cap.NOTE:This operation is required to release the inner pressure of the fuel ...
Seatbelt safety tips
WARNING
All persons in the vehicle should
fasten their seatbelts BEFORE
the vehicle starts to move. Otherwise,
the possibility of serious
injury becomes greater in the
event of a sudden stop or accident.
All belts should fit snugly in order
to provide full restraint. Loose
fittin ...
