Subaru Crosstrek Service Manual: Continuously variable transmission(tr580)
- Air breather hose
- Automatic transmission assembly
- Awd on/off switching mode
- Control valve body
- Converter case
- Cvtf
- Cvtf cooler (with warmer function)
- Cvtf filter
- Differential gear oil
- Differential side retainer oil seal
- Drive pinion shaft assembly
- Drive plate
- Extension case
- Extension case oil seal
- Forward clutch assembly
- Front differential assembly
- General description
- Inhibitor switch
- Oil pan and strainer
- Oil pump
- Oil pump chain
- Parking pawl
- Preparation for overhaul
- Primary pulley and secondary pulley
- Primary speed sensor
- Reduction drive gear
- Reduction driven gear
- Reverse brake assembly
- Secondary pressure sensor
- Secondary speed sensor
- Torque converter assembly
- Transfer clutch
- Transfer driven gear
- Transmission case
- Transmission control device
- Transmission control module (tcm)
- Transmission harness
- Transmission mounting system
- Turbine speed sensor
- Variator chain
- Diagnostics with phenomenon Inspection
- Road test Inspection
- Secondary pressure (line pressure) test Inspection
- Stall test Inspection
- Time lag test Inspection
- Transfer clutch pressure test Inspection
Subaru select monitor Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. REA ...
Other materials:
Dtc u0073 control module communication bus off
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&q ...
Preparation tool
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionPREPARATION TOOL1. GENERAL TOOLTOOL NAMEREMARKSCircuit testerUsed for measuring resistance, voltage and current.NOTE:• For measuring standby current, prepare a circuit tester that can measure by 1 mA unit.• For measuring standby cur ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyADJUSTMENTSelection of main shaft rear plate:Measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.NOTE:Before measuring, tap the end of main shaft wi ...
