Subaru Crosstrek Service Manual: Body control system (diagnostics)
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u1500 keyless uart com. Malfunction
- Dtc b1016 shift lock circuit
- Dtc b1401 meter collation
- Dtc b1402 immobilizer key collation
- Dtc b1405 scu collation
- Dtc b1406 scu_eeprom
- Dtc b1407 met communication
- Dtc b1408 meter non-volatile memory
- Dtc b1409 scu communication
- Dtc b1410 transponder communication
- Dtc b1411 immobilizer antenna
- Dtc b1010 body control system (biu) malfunction
- Dtc b1011 battery control power supply
- Dtc b1012 battery backup power supply
- Dtc b1013 ignition power
- Dtc b1014 acc power
- Dtc b1015 key interlock circuit
- General description
- Read current data
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Control module i/o signal Electrical specification
- Electrical component location Location
- Function check Operation
- General diagnostic table Inspection
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
- Registration body integrated unit Operation
- User customizing Operation
Outer mirror assembly Note
Blind Spot Detection/Rear Cross Traffic Alert > Outer Mirror AssemblyNOTEFor the operation procedures for the outer mirror assembly, refer to “GLASS/WINDOWS/MIRRORS” section. Outer Mir ...
Other materials:
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the air flow control dial or switch to check that the link operates normally.3. If it does not operate normally ...
General diagnostic table Inspection
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General Diagnostic TableINSPECTIONSymptomsFaulty partsTire pressure warning light illuminates.Tire pressure is reduced.• Improper tire pressure adjustment• Punctured tireTire pressure warning light blinks 25 times and then illuminates.Ti ...
Inspection
COMMUNICATION SYSTEM > HornINSPECTION1. CHECK HORN ASSEMBLY1. Remove the horn assembly (Hi & Lo). Horn > REMOVAL">2. Check the horn sounds when applying the battery voltage to the horn assembly.Terminal No.Inspection conditionsSpecificationHorn terminal (+) — Horn case (−) ...
