Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Top tether anchorages

Your vehicle is equipped with three top tether anchorages so that a child restraint system having a top tether can be installed in the rear seat. When installing a child restraint system using top tether, proceed as follows, while observing the instructions by the child restraint system manufacturer.

Since a top tether can provide additional stability by offering another connection between a child restraint system and the vehicle, we recommend that you use a top tether whenever one is required or available.

Installation of child restraint systems by use of lower and tether anchorages (LATCH)
WARNING Child restraint systems and seatbelts can become hot in a vehicle that has been closed up in sunny weather; they could burn a small child. Check the child restraint system before ...

Anchorage location
For left seat For center seat For right seat Three upper anchorages are installed on the back side of the rear seatback. ...

Other materials:

Removal
STARTING/CHARGING SYSTEMS(H4DO) > Battery Current & Temperature SensorREMOVAL1. BATTERY CURRENT SENSORNOTE:Remove the battery current sensor and battery cable as a unit.1. Disconnect the battery ground cable and remove the clip from the battery rod.2. Remove the battery terminal boot.3. Remov ...

Assembly
CLUTCH SYSTEM > Master CylinderASSEMBLY1. Apply a coat of grease to the contact surfaces of the push rod and piston before installation.Grease:SILICONE GREASE G-40M or equivalent2. Assemble in the reverse order of disassembly.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb) ...

Installation
EXTERIOR/INTERIOR TRIM > Side GarnishINSTALLATIONCAUTION:Do not reuse the garnish assembly. Deformation occurs on the garnish assembly when once removed, and this may cause improper adhesion.1. Install each part in the reverse order of removal.2. Install the garnish assembly - fender and the garn ...

© 2016-2025 Copyright www.sucross.com