WARNING
This may cause loss of vehicle control and result in personal injury.
1. Adjust the seat position. Refer to "Front seats"
2. Pull the tilt/telescopic lock lever down.
3. Move the steering wheel to the desired level.
4. Pull the lever up to lock the steering wheel in place.
5. Make sure that the steering wheel is securely locked by moving it up and down, and forward and backward.
Horn
To sound the horn, push the horn pad.
New vehicle break-in driving - the first 1,000 miles (1,600 km)
The performance and long life of your
vehicle are dependent on how you handle
and care for your vehicle while it is new.
Follow these instructions during the first
1,000 miles (1,600 km):
Do not race the engine. And do not
allow engine speed to exceed 4,000 rpm
except in an emergency
...
Dtc u0131 lost communication with power steering control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0131 LOST COMMUNICATION WITH POWER STEERING CONTROL MODULEDTC DETECTING CONDITION:No data is received from power steering CM.TROUBLE SYMPTOM:Cooperation control with power steering CM does not operate properly. ...
Replacement
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Oil SealREPLACEMENT1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Clean the transmission exterior.4. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.CAUTION:• Immediately after ...