Subaru Crosstrek Owners Manual: Screen settings
The items in screen settings can be set.
To change the items, operate the "
"
or
"
" switch, and then push the
button.
- Preparation for screen settings
- Top display setting
- Fuel consumption screen setting
- Economy history setting
- Triple meter setting
- Clock/calendar screen setting
- Bypass screen setting
- Language setting
Beep volume setting
1. Perform the preparation steps according
to "Preparation for image quality and
volume settings"
2. Operate the "
" or "
" switch to
select the "Beep" item. Then push the
button.
...
Preparation for screen settings
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the
button to show
the selection screen.
3. After the selection screen is displayed,
operate the "
" or "
...
Other materials:
Replacement
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Differential Side Retainer Oil SealREPLACEMENT1. Disconnect the ground cable from battery.2. Remove the front tires.3. Lift up the vehicle.4. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.CAUTION:• ...
Component
DRIVE SHAFT SYSTEM > General DescriptionCOMPONENT1. PROPELLER SHAFT(1)Propeller shaft(3)Rear differential (T-type)Tightening torque: N·m (kgf-m, ft-lb)(2)Rear differential (VA1-type) T1:31 (3.2, 22.9) T2:52 (5.3, 38.4)2. FRONT AXLE• EBJ + PTJ type(1)Circlip(8)Boot (PTJ)(15)Front ...
Operation
SECURITY AND LOCKS > Impact SensorOPERATION1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR1. Make an impact sensor setting.(1) Connect the Subaru Select Monitor.NOTE:For detailed operation procedures, refer to “Application help”.(2) Turn the ignition switch to ON.(3) On «Start» ...
