Subaru Crosstrek Service Manual: Repair
GLASS/WINDOWS/MIRRORS > Rear Window Defogger System
REPAIR
1. Clean the broken portion with alcohol or appropriate cleaning solvent.
2. Mask both side of wire with masking tape.
3. Apply the conductive silver composition to the broken portion.
Preparation items:
Conductive silver composition: Permatex QUICK GRID
(1) | Broken portion |
(2) | Masking tape |
(3) | Broken wire |
(4) | Conductive silver composition |
4. Dry using a dryer after applying the composition.
5. After repair, check the wire.
Wiring diagram
GLASS/WINDOWS/MIRRORS > Rear Window Defogger SystemWIRING DIAGRAMRefer to “Rear Defogger System” in the wiring diagram. Rear Defogger System > WIRING DIAGRAM"> ...
Rearview mirror
...
Other materials:
BSD/RCTA approach indicator light
BSD/RCTA approach indicator light
It is mounted on each side of the outside
mirrors.
The indicator light will illuminate when a
vehicle approaching from behind is detected.
The indicator light will flash to warn the
driver of dangers under the following
conditions.
While the indic ...
Note
VEHICLE DYNAMICS CONTROL (VDC) > Vehicle Dynamics Control SystemNOTEFor operation procedures of each component of the vehicle dynamics control system, refer to the respective section.• VDC control module & hydraulic control unit (VDCCM&H/U): VDC Control Module and Hydraulic Control ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...
