EXTERIOR/INTERIOR TRIM > Floor Under Protector
REMOVAL
1. Lift up the vehicle.
NOTE:
A plate type lift cannot be used.
2. Remove the bolts and clips, and remove the floor under protector.
Auto light sensor sensitivity setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Auto Light Sensor" item. Then
push the button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Selec ...
Dtc p2009 tgv control circuit low bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2009 TGV CONTROL CIRCUIT LOW BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION"& ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle BodyINSPECTION1. THROTTLE SENSOR (METHOD WITH CIRCUIT TESTER)1. Remove the glove box. Glove Box > REMOVAL">2. Turn the ignition switch to ON. (engine OFF)3. Measure the voltage between ECM connector terminals.(A)To ECM connector Thrott ...