Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Relay and fuse

Location
EyeSight > General DescriptionLOCATIONRefer to “LOCATION” of “EyeSight (DIAGNOSTICS)” section. Electrical Component Location > LOCATION"> ...

Inspection
EyeSight > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harnes ...

Other materials:

Dtc b1633 curtain airbag sensor rh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1633 CURTAIN AIRBAG SENSOR RH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (RH)• Side airbag sensor (RH) ...

Dtc b1402 immobilizer key collation
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1402 IMMOBILIZER KEY COLLATIONDTC DETECTING CONDITION:• Incorrect immobilizer key (use of unregistered key in body integrated unit)• Faulty antenna• Communication failure between key and body ...

Adjustment
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)ADJUSTMENT1. VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight)After installing, replacing or adjusting the following parts, perform the VDC sensor midpoint setting mode.• Steering angle se ...

© 2016-2025 Copyright www.sucross.com