Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Power steering control module

Preparation tool
POWER ASSISTED SYSTEM (POWER STEERING) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS34099PA100SPANNERUsed when measuring the rotational resistance of ...

Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Power Steering Control ModuleINSTALLATION1. Install each part in the reverse order of removal.CAUTION:Make sure that the connector is securely locked.Tighte ...

Other materials:

Diagnostic procedure with cancel code Dtc b2328 rear radar internal failure (radar misalignment)
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Cancel CodeDTC B2328 REAR RADAR INTERNAL FAILURE (RADAR MISALIGNMENT)DETECTING CONDITION:• Excessive impact was given to the installation area of the radar sensor, which resulted in deviation of the rada ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...

Replacing bulbs
WARNING Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury. CAUTION Replace any bulb only with a new bulb of the specified wattage. Using a bulb of differe ...

© 2016-2025 Copyright www.sucross.com