Subaru Crosstrek Owners Manual: Parking brake stroke
Check the parking brake stroke according to the maintenance schedule in the "Warranty and Maintenance Booklet".
When the parking brake is properly adjusted, braking power is fully applied by pulling the lever up 7 to 8 notches gently but firmly (approximately 45 lbf [200 N, 20.4 kgf]). If the parking brake lever stroke is not within the specified range, have the brake system checked and adjusted at your SUBARU dealer.
Replacement of brake pad and lining
The disc brakes have audible wear
indicators on the brake pads. If the brake
pads wear close to their service limit, the
wear indicator makes a very audible
scraping noise when the brake pedal ...
Tires and wheels
...
Other materials:
Electrical component location Location
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Outer mirror assembly RH(3)Radar sensor RH (slave)(5)BSD/RCTA OFF switch(2)Outer mirror assembly LH(4)Radar sensor LH (master)(6)Data link connector ...
Dtc p0507 idle control system rpm - higher than expected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0507 IDLE CONTROL SYSTEM RPM - HIGHER THAN EXPECTEDDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:Engine keeps running at higher speed than specified idl ...
Preparation for car settings
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the button to
show
the selection screen.
3. After the selection screen is displayed,
operate the " " or "
" switch to show the
"Car Setting" item. Then, push the
button. ...
