Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Operation

EyeSight (DIAGNOSTICS) > ACC Cancel Code(s) Display

OPERATION

When the ACC cancel code is detected from the stereo camera, the cruise control will be cancelled.

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «EyeSight» and select «Enter».

5. On «Select Function» display, select «Cancel Code».

6. On «Cancel Code» display, select «Cancel Code of ACC Cruise Control».

NOTE:

For detailed operation procedures, refer to “Application help”.

Up to 8 codes can be stored. When more than eight codes are output, the oldest code will be deleted to store the latest code.

Stored codes will be cleared by Clear Memory.

For details on ACC cancel codes, refer to List of ACC cancel code. ACC Cancel Code(s) Display > LIST">

List
EyeSight (DIAGNOSTICS) > ACC Cancel Code(s) DisplayLIST• List of ACC cancel code(s)ACC cancel codeItemContents of diagnosis02ACC Mode:Maintaining Standstill PositionDisplayed when the cruise ...

Control module i/o signal
...

Other materials:

Canceling the function for meter/gauge needle movement upon turning on the ignition switch
It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the "ON" position. Type A combination meter To change the setting, perform the following procedure. 1. Turn the ignition switch to the "LOCK"/ ...

Rear center seating position
CAUTION The head restraint is not intended to be used at the retracted position. Before sitting on the seat, raise the head restraint to the extended position. Incorrect (retracted position) Correct (extended position) To raise: Pull the head restraint up. To lower: Push ...

Dtc b19f3 short in front p/t 2 rh (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B19F3 SHORT IN FRONT P/T 2 RH (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Lap seat belt pretensioner (RH) circuit is shorted to power supply.• Lap seat belt pretensioner ...

© 2016-2025 Copyright www.sucross.com