Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Operating ranges

Operating ranges

  1. Antenna
  2. Operating range

Operating ranges

  1. LED indicator

When the access key is within either of the operating ranges of the front doors, the LED indicator on the access key flashes.

When the keyless access functions are disabled, the LED indicator does not flash unless a button on the access key is pressed.

Operating range tips Regarding malfunction:

The keyless access function may not operate properly due to the following reasons.

Precautions:

When the access key is within the operating range, it is possible for anyone, even someone who is not carrying the access key, to operate the keyless access function. Please note that the keyless access function is only available for the following items when the access key is detected within operating range.

It is not possible to lock the doors and rear gate using the keyless access function when the access key is inside the vehicle. However, depending on the status of the access key and the environmental conditions, the access key may be locked inside the vehicle. Before locking the doors and rear gate, make sure that you have the access key.

The operating range may be reduced, or the keyless access function may not operate in the following cases:

In such a case, perform the procedure described in "Locking and unlocking"  9-17.

When an access key is in the operating range, if the door handle becomes wet due to exposure to a significant amount of water when the vehicle is washed or during heavy rain, the doors may be locked or unlocked.

Locking and unlocking with "keyless access" entry function
...

How to use keyless access functions
Keyless access function tips Turn off the push-button ignition switch before locking the doors (including rear gate) using the keyless access function. It is not possible to lock the doors ( ...

Other materials:

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil PumpINSTALLATION1. Install the O-ring.NOTE:• Use new O-rings.• Apply CVTF to the O-ring.2. Install the plate and the oil pump.NOTE:Apply CVTF to the bolt.Tightening torque:8.5 N·m (0.9 kgf-m, 6.3 ft-lb)3. Install the oil pump chai ...

Removal
LIGHTING SYSTEM > Turn Signal Light & Hazard Light UnitREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable fro ...

Dtc b1900 short in front p/t rh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1900 SHORT IN FRONT P/T RHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (RH) circuit is shorted.• Pretensioner (RH) is faulty.• Pretensioner harness ...

© 2016-2024 Copyright www.sucross.com