When maintenance and service are required, it is recommended that all work be done by an authorized SUBARU dealer.
If you perform maintenance and service by yourself, you should familiarize yourself with the information provided in this section on general maintenance and service for your SUBARU.
Incorrect or incomplete service could cause improper or unsafe vehicle operation.
Any problems caused by improper maintenance and service performed by you are not eligible for warranty coverage.
WARNING
Remember that some of the materials in the vehicle may be hazardous if improperly used or handled, for example, battery acid.
This will cause a fire.
NOTE
SUBARU does not endorse the use of non-SUBARU approved flushing systems and strongly advises against performing these services on a SUBARU vehicle. Non-SUBARU approved flushing systems use chemicals and/or solvents which have not been tested or approved by SUBARU.
SUBARU warranties do not cover any part of the vehicle which is damaged by adding or applying chemicals and/or solvents other than those approved or recommended by SUBARU.
Dtc c0064 normal closing valve 2 malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0064 NORMAL CLOSING VALVE 2 MALFUNCTIONDTC detecting condition:• Defective harness connector• Defective VDCH/U solenoid valveTrouble symptom:• ABS does not operate.• ...
Installation
ENTERTAINMENT > Front Accessory Power Supply SocketINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Manifold Absolute Pressure SensorREMOVAL1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from the manifold absolute pressure sensor, and remove the manifold absolute pressure sensor from intake manifold. ...