Subaru Crosstrek Service Manual: Location
WIPER AND WASHER SYSTEMS > Relay and Fuse
LOCATION
Main fuse box | Fuse 30 A (wiper) | (A) |
Relay & fuse box | Fuse 7.5 A (wiper) | (B) |
Relay holder | Wiper relay | (C) |
NOTE:
For other related fuses, refer to the wiring diagram. Power Supply Circuit">
Inspection
WIPER AND WASHER SYSTEMS > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.2. CHECK RELAY1. Check the resistance between r ...
Other materials:
Dtc p2196 a/f /o2 sensor signal biased/stuck rich bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2196 A/F /O2 SENSOR SIGNAL BIASED/STUCK RICH BANK 1 SENSOR 1DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Cle ...
Caution
INTAKE (INDUCTION)(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, ...
Airflow mode selection
To select the airflow mode:
Type A, B and C: Turn the airflow mode
selection dial.
Type D: Press the airflow mode selection
button.
To select the defrost mode:
Type A and B: Turn the airflow mode
selection dial.
Type C and D: Press the defroster button.
Airflow modes are as follows. ...
