Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Light control switch

CAUTION

Models with "keyless access with push-button start system": The light control switch operates when the push-button ignition switch is in the "ACC" or "ON" position.

Regardless of the position of the light control switch, the illuminated lights are turned off when the push-button ignition switch is turned off.

Models without "keyless access with push-button start system": The light control switch operates when the key is inserted in the ignition switch.

Regardless of the position of the light control switch, the illuminated lights are turned off when the key is removed from the ignition switch.

NOTE

The light control switch can be operated (except auto on/off headlights), even under the following conditions.

If the driver's door is opened while the headlights are illuminated under such conditions, a chirp sound will inform the driver that the lights are illuminated.

Lifetime fuel consumption resetting
1. Perform the preparation steps according to "Preparation for initialization" 2. Operate the " " or " " switch to select the "Lifetime Fuel Consumption Resetting" item. Then push the butto ...

Headlights
To turn on the headlights, turn the knob on the end of the turn signal lever. " " position Instrument panel illumination, headlights, parking lights, front side marker lights, rear side marke ...

Other materials:

General diagnostic table Inspection
CLUTCH SYSTEM > General Diagnostic TableINSPECTION1. CLUTCHSymptomsPossible causeCorrective action1. Clutch slippageIt is hard to perceive clutch slippage in the early stage, but pay attention to the following symptoms.• Engine temporarily speeds up when the accelerator ON immediately after ...

Component
BRAKE > General DescriptionCOMPONENT1. FRONT DISC BRAKE(A)Shim-separate brake pad type(B)Shim-integrated brake pad type (1)Caliper body(11)Pad clip - upper(19)Cap - bleeder(2)Bleeder - screw(12)Pad clip - lower (3)Guide pin - front brake (black)(13)Shim - disc brake front*1:17 mm (width a ...

Dtc p2096 post catalyst fuel trim system too lean bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2096 POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...

© 2016-2025 Copyright www.sucross.com