Subaru Crosstrek Service Manual: Installation
WHEEL AND TIRE SYSTEM > Tire and Wheel
INSTALLATION
1. Install the wheels to vehicle.
2. Tighten the wheel nuts to the specified torque.
Tightening torque:
Except for C4 model: 120 N·m (12.24 kgf-m, 88.5 ft-lb)
C4 model: 100 N·m (10.2 kgf-m, 73.8 ft-lb)
Removal
WHEEL AND TIRE SYSTEM > Tire and WheelREMOVAL1. Lift up the vehicle.2. Remove the wheel nut.3. Remove the wheels.CAUTION:When removing the wheels, be careful not to damage the bolt - hub. ...
Other materials:
Tire care - maintenance and safety practices
Check on a daily basis that the
tires are free from serious damage,
nails, and stones. At the same time,
check the tires for abnormal wear
Inspect the tire tread regularly
and replace the tires before their
tread wear indicators become visible.
When a tire's tread wear
indicator b ...
Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearDISASSEMBLY1. Using the ST, remove the taper roller bearing (extension case side).ST 498077000REMOVER(A)Taper roller bearing (extension case side)2. Using ST1 and ST2, remove the taper roller bearing (transfer case side).ST1 49 ...
Dtc p2096 post catalyst fuel trim system too lean bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2096 POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...
