Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

SPEED CONTROL SYSTEMS(H4DO) > Accelerator Pedal

INSTALLATION

Install in the reverse order of removal.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

Inspection
SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalINSPECTION1. CHECK ACCELERATOR PEDAL SENSOR AREA (METHOD WITH CIRCUIT TESTER)1. Remove the glove box. Glove Box > REMOVAL">2. Turn the ign ...

General description
...

Other materials:

Removal
INTAKE (INDUCTION)(H4DO) > Air Cleaner ElementREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B). ...

Dtc b14e2 air mix door actuator stepping motor circuit short-circuit (driver)
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E2 AIR MIX DOOR ACTUATOR STEPPING MOTOR CIRCUIT SHORT-CIRCUIT (DRIVER)DTC detecting condition:Air mix door actuator stepping motor circuit is shorted.Trouble symptom:Temperature cannot be adjusted ...

Disassembly
BRAKE > Master CylinderDISASSEMBLY1. Remove the reservoir tank.CAUTION:Be careful not to tighten a vise excessively.(1) Place the master cylinder assembly between aluminum plates and fix it on a vise.(2) Drive out the pin using a punch and a hammer to remove the reservoir tank.2. Remove the seal ...

© 2016-2024 Copyright www.sucross.com