Subaru Crosstrek Service Manual: Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump Chain
INSPECTION
• Check the oil pump chain for damage.
• Replace if gear teeth are broken, damaged, sharpen or excessively worn.
• Check the bearing for seizure or wear.
• Apply CVTF to bearing and rotate the bearing to check for noise or dragging etc.
• Check the oil pump chain cover for damage.
• Check for leakage of CVTF from the mating surface of oil pump chain cover.
• Check the oil seal for damage.
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainDISASSEMBLY1. DRIVE SPROCKET1. Remove the snap ring.2. Remove the ball bearing using ST.ST1 498077600REMOVERST2 399513600INSTALLER ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainINSTALLATION1. Clean the mating surface of oil pump chain cover and converter case.2. Using the ST, install the oil seal.NOTE:• Use a ...
Other materials:
Electrical specification
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Auto A/C Control Module I/O SignalELECTRICAL SPECIFICATIONTerminal No.ContentMeasuring conditionStandard1Mode door actuator #4Digital signal; can not be measured — 2Mode door actuator #3Digital signal; can not be measured — 3Mode door actuator #2Digital ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission CaseADJUSTMENTNOTE:When replacing the transmission case with a new part, perform the following check and adjustment for the selection.• Select the transfer driven gear shim. Transfer Clutch > ADJUSTMENT">• Select the ...