Subaru Crosstrek Owners Manual: Engine exhaust gas (carbon monoxide)
WARNING
- Never inhale engine exhaust gas.
Engine exhaust gas contains
carbon monoxide, a colorless
and odorless gas which is dangerous,
or even lethal, if inhaled.
- Always properly maintain the engine
exhaust system to prevent
engine exhaust gas from entering
the vehicle.
- Never run the engine in a closed
space, such as a garage, except
for the brief time needed to drive
the vehicle in or out of it.
- Avoid remaining in a parked
vehicle for a lengthy time while
the engine is running. If that is
unavoidable, then use the ventilation
fan to force fresh air into
the vehicle.
- Always keep the front ventilator
inlet grille free from snow, leaves
or other obstructions to ensure
that the ventilation system always
works properly.
- If at any time you suspect that exhaust fumes are entering the
vehicle, have the problem
checked and corrected as soon
as possible. If you must drive
under these conditions, drive
only with all windows fully open.
- Keep the rear gate closed while
driving to prevent exhaust gas
from entering the vehicle.
NOTE
Due to the expansion and contraction
of the metals used in the manufacture
of the exhaust system, you may hear a
crackling sound coming from the exhaust
system for a short time after the
engine has been shut off. This sound is
normal.
The following suggestions will help to save
fuel.
Select the proper gear position for the
speed and road conditions.
Avoid sudden acceleration or deceleration.
Always accelerate gently un ...
The catalytic converter is installed in the
exhaust system. It serves as a catalyst to
reduce HC, CO and NOx in exhaust
gases, thus providing cleaner exhaust.
To avoid damage to the catalyti ...
Other materials:
Installation
EXHAUST(H4DO) > MufflerINSTALLATIONInstall in the reverse order of removal.NOTE:• Use a new gasket and self-locking nut.• After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb)Ti ...
Note
LIGHTING SYSTEM > Stop Light SystemNOTEFor operation procedures of each component of the stop light system, refer to the respective section.• Rear combination light assembly: Rear Combination Light Assembly">• Tail light/stop light bulb: Tail/Stop Light Bulb">• ...
Dtc b16f1 passenger s seat belt warning failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F1 PASSENGER’S SEAT BELT WARNING FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag control module is faulty.• Meter is faulty.• Harness circuits between ...
© 2016-2025 Copyright www.sucross.com
