Subaru Crosstrek Service Manual: Electrical specification
INSTRUMENTATION/DRIVER INFO > Combination Meter System
ELECTRICAL SPECIFICATION
1. COMBINATION METER ASSEMBLY
Refer to “Control Module I/O Signal” of “INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS)” section. Control Module I/O Signal > ELECTRICAL SPECIFICATION">
Wiring diagram
INSTRUMENTATION/DRIVER INFO > Combination Meter SystemWIRING DIAGRAMRefer to “Combination Meter System” in the wiring diagram.– Models with normal meters: Combination Meter System & ...
Other materials:
65
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code65Cruise control command switch malfunction is detected.While the command switch is pressed ON for a long time (approximately two minutes), stuck ON condition is detected.TROUBLE SYMPTOM:• Cruise control cannot be se ...
Dtc b2a0d airbag signal
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0D AIRBAG SIGNALDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Either the regular signal or collision signal cannot be detected from the airbag CM for at least 30 seconds. ...
Removal
DRIVE SHAFT SYSTEM > Rear AxleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the c ...