Subaru Crosstrek Service Manual: Dtc u0122 lost communication with vehicle dynamics control module
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULE
NOTE:
Refer to “LAN SYSTEM” for diagnostic procedure. Basic Diagnostic Procedure">
Dtc u1120 lost communication with autostart stop control module
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1120 LOST COMMUNICATION WITH AUTOSTART STOP CONTROL MODULENOTE:Refer to “LAN ...
Dtc c2511 torque sensor main
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2511 TORQUE SENSOR MAINTrouble symptom:• The steering wheel operation feels ...
Other materials:
Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...
Operation
HI - Rapid heating
LO - Normal heating
Off
Left-hand side
Right-hand side
To turn on the seat heater, push the "LO"
or "HI" position on the switch, as desired,
depending on the temperature.
Selecting the "HI" position will cause the
seat to heat up quicker.
To turn off ...
Reset to factory default settings
1. Perform the preparation steps according
to "Preparation for initialization"
2. Operate the " " or "
" switch to
select the "Reset to Defaults" item. Then
push the button.
3. The system will prompt a Yes/No
dialogue ("No" is selected first). To return
to the factory d ...
