Electrical specification
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONCAUTION:Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.Terminal No.Terminal nameInput/Output valueNote1Airbag CM commun ...
Installation
WIPER AND WASHER SYSTEMS > Rear Wiper MotorINSTALLATION1. Install each part in the reverse order of removal.2. Check that the mark on the cap - pivot wiper faces up, as shown in the figure.Tightening torque:Refer to “COMPONENT” of “General Description”. General Descriptio ...
Operating range for push-button start system
Antenna
Operating range
NOTE
If the access key is not detected
within the operating range of the antennas
inside the vehicle, the pushbutton
ignition switch and the engine
start cannot be operated.
Even when the access key is outside
the vehicle, if it is placed too close to
the ...