Subaru Crosstrek Service Manual: Diagnostics with phenomenon Inspection
CRUISE CONTROL SYSTEM > Diagnostics with Phenomenon
INSPECTION
Refer to “Diagnostics with Phenomenon” of “CRUISE CONTROL SYSTEM (DIAGNOSTICS)” section. Diagnostics with Phenomenon">
Control unit Note
CRUISE CONTROL SYSTEM > Control UnitNOTESystem control of the cruise control is performed by each module. For procedure, refer to the following sections.• Engine control module (ECM): Engine ...
Inhibitor switch Note
CRUISE CONTROL SYSTEM > Inhibitor SwitchNOTEFor the operation procedures for inhibitor switch, refer to “CONTINUOUSLY VARIABLE TRANSMISSION” section. Inhibitor Switch"> ...
Other materials:
Brake booster
If the brake booster does not operate as
described in the following, have it checked
by your SUBARU dealer.
1. With the ignition switch in the "LOCK"/
"OFF" position, depress the brake pedal
several times, applying the same pedal
force each time. The distance the pedal
travels should not va ...
Component
DRIVE SHAFT SYSTEM > General DescriptionCOMPONENT1. PROPELLER SHAFT(1)Propeller shaft(3)Rear differential (T-type)Tightening torque: N·m (kgf-m, ft-lb)(2)Rear differential (VA1-type) T1:31 (3.2, 22.9) T2:52 (5.3, 38.4)2. FRONT AXLE• EBJ + PTJ type(1)Circlip(8)Boot (PTJ)(15)Front ...
Dtc p2530 ignition switch run position circuit
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom:Faulty TCM operationCAUTION:Use the check board when measuring the TCM te ...
