Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Coolant temperature low indicator light/Coolant temperature high warning light

Subaru Crosstrek Owners Manual / Instruments and controls / Warning and indicator lights / Coolant temperature low indicator light/Coolant temperature high warning light

CAUTION

After turning the ignition switch to the "ON" position, if this indicator light/warning light behaves in any of the following ways, the electrical system may be malfunctioning. Contact your SUBARU dealer immediately for an inspection.

While driving, if this indicator light/warning light behaves in any of the following ways, take the specified appropriate measure listed below.

Blinking or illuminated in RED: Safely stop the vehicle as soon as possible, and refer to the emergency steps to take in the case of engine overheating. After that, have the system checked by your nearest SUBARU dealer. Refer to "Engine overheating" 9- 12.

Blinking in RED and BLUE alternately: The electrical system may be malfunctioning. Contact your SUBARU dealer for an inspection.

This coolant temperature low indicator light/coolant temperature high warning light has the following three functions.

For a system check, this indicator light/ warning light illuminates in RED for approximately 2 seconds when the ignition switch is turned to the "ON" position.

After that, this indicator light/warning light changes to BLUE and maintains illumination in BLUE. This BLUE illuminated light turns off when the engine is warmed up sufficiently.

If the engine coolant temperature increases over the specified range, the indicator light/warning light blinks in RED. At this time, the engine is close to overheating.

If the engine coolant temperature increases further, the indicator light/warning light illuminates in RED continuously. At this time, the engine may be overheating.

When the indicator light/warning light blinks in RED or illuminates in RED, safely stop the vehicle as soon as possible, and refer to the emergency steps to take in the case of engine overheating. Refer to "Engine overheating" 9-12. After that, have the system checked by your nearest SUBARU dealer.

Also, if the indicator light/warning light often blinks in RED, the electrical system may be malfunctioning. Contact your SUBARU dealer for an inspection.

NOTE

If the engine is restarted after a certain driving condition, this indicator light/ warning light may illuminate in RED.

However, this is not a malfunction if the indicator light/warning light turns off after a short time.

Check engine warning light/Malfunction indicator light
CAUTION If the CHECK ENGINE light illuminates while you are driving, have your vehicle checked/repaired by your SUBARU dealer as soon as possible. Continued vehicle operation without having the ...

Charge warning light
If this light illuminates when the engine is running, it may indicate that the charging system is not working properly. If the light illuminates while driving or does not turn off after the ...

Other materials:

Dtc b2a0d airbag signal
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0D AIRBAG SIGNALDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Either the regular signal or collision signal cannot be detected from the airbag CM for at least 30 seconds. ...

Front seats
WARNING Never adjust the seat while driving to avoid loss of vehicle control and personal injury. Before adjusting the seat, make sure the hands and feet of rear seat passengers and cargo are clear of the adjusting mechanism. After adjusting the seat, push it slightly to make sur ...

Malfunction indicator light does not blink
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT BLINKDIAGNOSIS:• The malfunction indicator light circuit is open or shorted.• The delivery (test) mode fuse circuit is open.TROUBLE SYMPTOM:Malfunction indicator light does not blink during In ...

© 2016-2024 Copyright www.sucross.com