Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Control screen and audio panel

Subaru Crosstrek Owners Manual / Audio / Audio set / AM/FM radio / Control screen and audio panel

Control screen and audio panel

  1. Select to display the audio source selection screen.
  2. Select to change the band.
  3. The HD Radio indicator on the top right of the screen changes according to the reception condition of HD Radio (if equipped).
  4. Select to display a station list (if equipped). Refer to "Selecting a station from the list"
  5. Select to scan radio channels.

    This function enables searching for receivable stations automatically, and tunes in to a frequency for 5 seconds if a station is found. When the 5-second period has elapsed, the system searches for the next receivable station again, and tunes in to the frequency for 5 seconds.

  6. Select to open the "Option" screen.

    Refer to "Radio settings"

  7. When you touch a key, the system tunes to the stored frequency.

    When you touch and hold a key, the system stores the frequency to the selected preset channel. Refer to "Presetting a station"

  8. Turn to adjust volume.

    Press to turn the audio system on/ off.

  9. Turn to step up/down frequencies.

    Turn to move up/down the list. Also, the knob can be used to enter selections on the list screens by pressing.

    Press to select an audio mode. For details, refer to "Selecting an audio source"

  10. Press to display the sound setting screen. Refer to "Unit settings"
  11. Press to seek for a station/channel.

    Press and hold for continuous seek.

NOTE

How to change the source

Select the "AM" or "FM" key on the source select screen. Refer to "Selecting an audio source"

AM/FM radio
...

Presetting a station
In total 18 stations can be set for the FM band (6 each for FM1, FM2 and FM3) and 12 stations can be set for the AM band (6 each for AM1 and AM2). 1. Tune in the desired station. 2. If you to ...

Other materials:

Initial screen
When the ignition switch is in the "ACC" or "ON" position, the initial screen will be displayed and the system will begin operating. When using the SUBARU STARLINK function (if equipped), the display screen may be different from the screen above. After a few seconds, the caution scr ...

Inspection
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the latch and actuator - rear gate.2. ACTUATORPreparation tool:Circuit tester1. Check door lock ope ...

Dtc u0401 invalid data received from ecm/pcm a
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”DTC DETECTING CONDITION:Defective data from ECM.TROUBLE SYMPTOM:Defective data on CAN communication occurs.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNO ...

© 2016-2025 Copyright www.sucross.com