Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Combination meter Note

Blind Spot Detection/Rear Cross Traffic Alert > Combination Meter

NOTE

For the operation procedures for combination meter, refer to “INSTRUMENTATION/DRIVER INFO” section. Combination Meter">

Blind spot detection/rear cross traffic alert
Note Blind Spot Detection/Rear Cross Traffic Alert > Blind Spot Detection/Rear Cross Traffic AlertNOTEFor procedure of each component in the Subaru Rear Vehicle Detection system, refer to the resp ...

Diagnostics with phenomenon Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Diagnostics with PhenomenonINSPECTIONRefer to “Diagnostics with Phenomenon” of “Blind Spot Detection/Rear Cross Traffic Alert (DIAG ...

Other materials:

Operation
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Subaru Select MonitorOPERATIONFor detailed operation procedures, refer to “Application help”.NOTE:If TPMS & keyless entry CM or TPMS CM and Subaru Select Monitor cannot communicate, check the communication circuit. Subaru Select Mon ...

Inspection
LIGHTING SYSTEM > Hazard SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply battery voltage between the connector terminals to check the lighting ...

Dtc p2138 throttle/pedal position sensor/switch "d"/"e" voltage correlation
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2138 THROTTLE/PEDAL POSITION SENSOR/SWITCH "D"/"E" VOLTAGE CORRELATIONDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Poor driving pe ...

© 2016-2025 Copyright www.sucross.com