Subaru Crosstrek Service Manual: Clear memory mode Operation
EyeSight (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «EyeSight» and select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
Check list for interview Check
EyeSight (DIAGNOSTICS) > Check List for InterviewCHECKInspect the following items regarding the vehicle’s state.Writer/InspectorWriter’s name Inspector’s Name Vehicle informationC ...
Electrical component location Location
EyeSight (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Stereo camera(5)EyeSight steering switch(9)Transmission control module (TCM)(2)VDC control module (VDCCM)(6)MFD (multi-function disp ...
Other materials:
Dtc b2220 break the wire of ign
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2220 BREAK THE WIRE OF IGNDTC detecting condition:There was voltage malfunction caused by poor contact of IGN power supply circuits.Trouble symptom:Airbag indicator does not illuminate.Wiring d ...
Installation
SEATS > Rear SeatINSTALLATIONInstall each part in the reverse order of removal.NOTE:• After installing the backrest assembly, make sure that each seat belt operates normally.• Make sure that they are properly secured on each hook on the vehicle side.Tightening torque:Refer to “C ...
Inspection
FRONT SUSPENSION > Front StrutINSPECTIONCheck the removed part for wear, damage and cracks, and then repair or replace it if defective.1. STRUT1. Check for oil leaks.2. Move the piston rod up and down to check that it operates smoothly without any hitch.3. Check the piston rod runout.Preparation ...
