Subaru Crosstrek Owners Manual: Before starting out on a trip
- Check the towing regulations for trailer
or caravan vehicles that vary by state/
region. Failure to comply with the procedures
set forth will not only compromise
your safety, but will also negate your
insurance coverage and/or may violate
the state road and traffic acts and regulations.
- Check that the vehicle and vehicle-tohitch
mounting are in good condition. If
any problems are apparent, do not tow the
trailer.
- Check that the vehicle rests horizontally
with the trailer attached. If the vehicle
is tipped sharply up at the front and down
at the rear, check the total trailer weight,
GVW, GAWs and tongue load again, then
confirm that the load and its distribution
are acceptable.
- Check that the tire rating and pressures
are correct.
- Check that the vehicle and trailer are
connected properly. Confirm that:
the trailer tongue is connected
properly to the hitch ball.
the trailer lights connector is connected
properly and trailer's brake
lights illuminate when the vehicle's
brake pedal is pressed, and that the
trailer's turn signal lights flash when
the vehicle's turn signal lever is operated.
the safety chains are connected
properly.
all cargo in the trailer is secured
safely in position.
the side mirrors provide a good
rearward field of view without a significant
blind spot.
- Sufficient time should be taken to learn
the "feel" of the vehicle/trailer combination
before starting out on a trip. In an area free
of traffic, practice turning, stopping and
backing up.
CAUTION
For models equipped with the
BSD (Blind Spot Detection) and
RCTA (Rear Cross Traffic Alert)
driving support systems, when
towing a trailer, press the BSD/
RCTA OFF switch to deac ...
You should allow for considerably more
stopping distance when towing a trailer.
Avoid sudden braking because it may
result in skidding or jackknifing and loss of
control.
Avoid abrupt s ...
Other materials:
Installation
LUBRICATION(H4DO) > Oil Pressure SwitchINSTALLATION1. Apply liquid gasket to the oil pressure switch threads.Liquid gasket:THREE BOND 1324 (Part No. 004403042) or equivalent2. Install the oil pressure switch to the chain cover.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)3. Connect the ...
Installation
MECHANICAL(H4DO) > Chain CoverINSTALLATION1. Install the O-rings to cylinder head RH, cylinder head LH, cylinder block LH and oil pan upper.NOTE:• Use new O-rings.• Apply a coat of engine oil to the O-rings.2. Apply liquid gasket if there are gaps between front camshaft cap and cam ca ...
Inspection
SECURITY AND LOCKS > Door Lock Control SystemINSPECTION1. SYMPTOM CHARTSymptomsRepair orderReferenceThe door lock control system does not operate.1. Remove and visually inspect the following fuses.• No. 3 (in fuse & relay box)• No. 7 (in fuse & relay box)• No. 8 (in main ...
© 2016-2025 Copyright www.sucross.com
