Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Airflow mode selection

To select the airflow mode: Type A, B and C: Turn the airflow mode selection dial.

Type D: Press the airflow mode selection button.

To select the defrost mode: Type A and B: Turn the airflow mode selection dial.

Type C and D: Press the defroster button.

Airflow modes are as follows.

Airflow mode selection

(Ventilation): Instrument panel outlets

Airflow mode selection

(Bi-level): Instrument panel outlets and foot outlets

Airflow mode selection

(Heat): Foot outlets, both side outlets of the instrument panel and some through windshield defroster outlets (A small amount of air flows to the windshield and both side windows to prevent fogging.)

Airflow mode selection

(Heat-def): Windshield defroster outlets, foot outlets and both side outlets of the instrument panel (Refer to "Defrosting" F4-11.)

Airflow mode selection

(Defrost): Windshield defroster outlets and both side outlets of the instrument panel (Refer to "Defrosting"

Manual climate control operation
...

Temperature control
Type A Turn the temperature control dial over a range from the blue side (cool) to red side (warm) to regulate the temperature of airflow from the air outlets. Type B, C and D Turn the temperatu ...

Other materials:

Dtc p0138 o2 sensor circuit high voltage bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0138 O2 SENSOR CIRCUIT HIGH VOLTAGE BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...

Inspection
DIFFERENTIALS > Rear Differential (VA-type)INSPECTIONWash all the disassembled parts clean, and examine them for wear, damage or other defects. Repair or replace the defective parts as necessary.1. Hypoid driven gear and drive pinion• If there is evidently an abnormal tooth contact, find ou ...

Installation
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyINSTALLATION1. Before installation, check the following items.• Lever is free from deformation.• Grease is applied sufficiently to lever joints.If grease is insufficient, add it as necessary before assembling.• ...

© 2016-2025 Copyright www.sucross.com