Subaru Crosstrek Owners Manual: Voice command example: Call
name
1. Press the talk switch on the steering
wheel.
2. Say "Call <contacts>"
NOTE
- In the same manner as it is displayed
on the screen, "Call <contacts>",
after saying "Call a contact"
say the name of a contact. For example:
"Call a contact", "John Smith" or
"Call a contact", "Mary Davis"
- Short or abbreviated names in the
contacts list may not be recognized.
Change names in the contacts list to
full names.
- Sometimes a voice recognition result
confirmation screen will be displayed.
After confirming the result, say "Yes" or "No".
- When the system recognizes multiple
names from the contacts list, a
name candidate list will be displayed
on the screen. If the desired name is
not displayed on the top of the screen,
say or select the number of the name
from the candidate list (number 1,
number 2, etc.) to select a name from
the candidate list.
- When a contact has multiple phone
numbers registered in the contacts list,
a candidate list will be displayed. If the
desired phone number is not displayed
on the top of the screen, say or select
the number of the desired phone
number from the candidate list (number
1, number 2, etc.) to select a phone
number from the candidate list.
1. Press the talk switch on the steering
wheel.
After the voice command top screen has
been displayed, speech guidance will
commence.
NOTE
When the voice command mode is
audio mode, voice ...
1. Press the talk switch on the steering
wheel.
2. Say "Dial number".
3. Say "Dial <number>".
For example, if the phone number is
2345678:
Say "two three four five six seven
eight"
...
Other materials:
Inspection
CLUTCH SYSTEM > FlywheelINSPECTIONCAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.(A)Flywheel(B)Ring gear2. Smooth ...
Dtc u1500 keyless uart com. Malfunction
BODY CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1500 KEYLESS UART COM. MALFUNCTION1. MODEL WITHOUT KEYLESS ACCESS WITH PUSH BUTTON START SYSTEMDTC detecting condition:UART between the TPMS & keyless control module or keyless entry CM and the bod ...
Installation
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorINSTALLATIONCAUTION:• Be careful not to damage the sensor.• Do not apply excessive force to the sensor harness.Install each part in the reverse order of removal.NOTE:• Check the identification (mark) on the harness to ...
© 2016-2024 Copyright www.sucross.com