Subaru Crosstrek Service Manual: Removal
VEHICLE DYNAMICS CONTROL (VDC) > Front Magnetic Encoder
REMOVAL
Refer to “Front Hub Unit Bearing” for removal, because the front magnetic encoder is integrated with the hub unit COMPL - front axle. Front Hub Unit Bearing > REMOVAL">
Inspection
VEHICLE DYNAMICS CONTROL (VDC) > Front Magnetic EncoderINSPECTIONVisually check the magnetic encoder for any damage. If necessary, replace with a new hub unit COMPL - front axle.NOTE:Because the ma ...
Installation
VEHICLE DYNAMICS CONTROL (VDC) > Front Magnetic EncoderINSTALLATIONRefer to “Front Hub Unit Bearing” for installation, because the front magnetic encoder is integrated with the hub unit ...
Other materials:
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...
Electrical specification
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION1. KEYLESS ACCESS CMTerminal No.Terminal symbolContent(B572) No. 2+B+B(B572) No. 3INDSStart switch indicator (green) output(B572) No. 5N-SWNeutral switch input(B572) No. 7STSWSTSW output( ...
Preparation tool
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOLCAUTION:To measure the voltage and resistance of airbag system and occupant detection system components, be sure to use the specified test harness.1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELEC ...
