Subaru Crosstrek Service Manual: Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunshade
REMOVAL
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the lid assembly - sunroof. Glass Lid > REMOVAL">
3. Remove the trim panel - roof assembly. Roof Trim > REMOVAL">
4. Remove the sunshade assembly.
(1) Attach protective tape (a) on the handle of sunshade assembly.
(2) Remove the left and right stoppers (b).
(3) Remove the sunshade assembly while pulling the center of the brace downward.
CAUTION:
Be careful not to damage the sunshade assembly.
Inspection
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeINSPECTION1. MOVING LOAD OF SUNSHADE ASSEMBLY1. Attach a spring scale together with a cloth to the edge of sunshade assembly.2. Pull the spring sca ...
Installation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeINSTALLATIONCAUTION:For installation of the stereo camera cover assembly, refer to “INSTALLATION”, “Stereo Camera” in the & ...
Other materials:
Switching power status
Operation indicator
Push-button ignition switch
The power status is switched every time
the push-button ignition switch is pressed.
1. Carry the access key, and sit in the
driver's seat.
2. Shift the select lever into the "P"
position.
3. Press the push-button ignition switch ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSTALLATIONCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.• After installing the secondary speed sensor, adjust t ...
Dtc b1628 side airbag sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1628 SIDE AIRBAG SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (LH) an ...
