Subaru Crosstrek Service Manual: Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check Sleeve
REMOVAL
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">
2. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">
3. Remove the shifter arm.
4. Remove the plug, gasket, reverse accent spring, and reverse check ball.
5. Remove the reverse check sleeve.
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveADJUSTMENT1. NEUTRAL POSITION ADJUSTMENT1. Shift the gear into 3rd gear position.2. Because of the return spring, until the arm conta ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveASSEMBLY1. Install the return spring (1st-2nd), return spring cap, reverse accent shaft, reverse check cam, return spring (5th-Revers ...
Other materials:
Caution
EyeSight (DIAGNOSTICS) > General DescriptionCAUTION1. AIRBAG SYSTEMAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage t ...
Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Subaru Select MonitorOPERATION• For detailed operation procedures, refer to “Application help”.• When the radar sensor cannot communicate with Subaru Select Monitor, perform “COMMUNICATION FOR INITIALIZING ...
Automatic engine shutdown
The remote engine start system will
automatically shut down or will not start
the engine under the following conditions.
The total run-time has exceeded 20
minutes.
Any door or the rear gate is opened.
The select lever is moved to any
position other than "P".
The engine hood is opene ...
